The Bramble Tall in white oak ships again from October 6
Reserve a pair
Every cabinet is 18 mm Baltic birch wrapped in walnut, cherry or white oak veneer, sanded to 220 grit and oiled three times. The sound is the same in all three.
Compare woodsBraced cabinet walls, a 5.25-inch paper-cone woofer and a 1-inch silk-dome tweeter, crossed over at 2.4 kHz.
We voice every model in a 14-by-18-foot living room with a rug, a couch and a full bookshelf, because that is the room it will play in.
Measured from the couch, 2.7 m away: ±2.5 dB from 48 Hz to 20 kHz.
Edges are eased with 220-grit paper and each cabinet gets three coats of hardwax oil, 24 hours apart. Light scratches buff out with the kit in the box.
See the finish
All three share one tweeter and one crossover slope, so a One pair and a Tall pair sound alike. Start small and add the Low when the room asks for it.



Plug the powered One into the wall, run the included cable to its partner, pick an input. The printed card shows where to stand them.
Setup guide
Turntable, TV, laptop or phone: phono, optical, USB-C and wireless inputs sit on the back panel.
See the back panel
Sit on our couch in Portland and play your own records through all three. Thursday to Sunday, 11 am to 6 pm.
Book a seat
Coat 3 of 3 · hardwax oil
Four of us cut, glue, sand and wire every cabinet in a 2,000-square-foot shop. Each back panel carries the build date and the initials of whoever made it.
Meet the shop →To your door in the lower 48.
Send them back on our label.
No interest, no fees.
Call (503) 555-0142 or write to hello@bramble-audio.example.